H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 545)

59-3
Configurations for the six output destinations function independently and take effect only after the
information center is enabled.
Outputting system information by source module
The system is composed of a variety of protocol modules, board drivers, and configuration modules.
The system information can be classified, filtered, and output by source module. Some source module
names and descriptions are shown in
Table 59-3 .
Table 59-3 Source module list
Module name Description
8021X 802.1X module
ACL Access Control List module
ARP Address Resolution Protocol module
BGP Border Gateway Protocol module
CFM Configuration File Management module
CLST Cluster Configuration module
CMD Command line module
default Default setting of all modules
DEV Device management module
DHCP Dynamic Host Configuration Protocol module
DNS Domain Name System module
ETH Ethernet module
FTPS FTP Server module
GARP Generic Attribute Registration Protocol module
HABP Huawei Authentication Bypass Protocol module
HWCM Huawei Configuration Management MIB module
IFNET Interface management module
IP Internet Protocol module
ISIS
Intermediate System-to-Intermediate System intra-domain routing information
exchange protocol module
LAGG Link Aggregation module
LINE Line module
MSDP Multicast Source Discovery Protocol module
MSTP Multiple Spanning Tree Protocol module
NAT Network Address Translation module
NTP Network Time Protocol module
PKI Public Key Infrastructure module