Configuring multicast group replacement – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 334

29-16
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter IGMP Snooping view
igmp-snooping
—
Enable IGMP report suppression
report-aggregation
Optional
Enabled by default
Configuring Maximum Multicast Groups that Can Be Joined on a Port
By configuring the maximum number of multicast groups that can be joined on a port, you can limit the
number of multicast programs on-demand available to users, thus to regulate traffic on the port.
Follow these steps to configure the maximum number of multicast groups that can be joined on a port or
ports:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
Enter the
corresponding view Enter port group
view
port-group
{ manual
port-group-name
| aggregation
agg-id
}
Use either command
Configure the maximum number of
multicast groups that can be joined on the
port(s)
igmp-snooping group-limit
limit
[ vlan vlan-list ]
Optional
The default is 128.
z
When the number of multicast groups a port has joined reaches the maximum number configured,
the system deletes all the forwarding entries persistent to that port from the IGMP Snooping
forwarding table, and the hosts on this port need to join the multicast groups again.
z
If you have configured static or simulated joins on a port, however, when the number of multicast
groups on the port exceeds the configured threshold, the system deletes all the forwarding entries
persistent to that port from the IGMP Snooping forwarding table and applies the static or simulated
joins again, until the number of multicast groups joined by the port comes back within the
configured threshold.
Configuring Multicast Group Replacement
For some special reasons, the number of multicast groups that can be joined on the current switch or
port may exceed the number configured for the switch or the port. In addition, in some specific
applications, a multicast group newly joined on the switch needs to replace an existing multicast group
automatically. A typical example is “channel switching”, namely, by joining a new multicast group, a user
automatically switches from the current multicast group to the new one.