Network diagram, Configuration procedure – H3C Technologies H3C WX6000 Series Access Controllers User Manual

Page 135

17-4

form one link connected to AC B and performs load sharing among these ports.

Network diagram

Figure 17-1

Network diagram for link aggregation configuration

AC A

Link aggregation

AC B

0/0/1

0/0/2

0/0/3

Configuration procedure

This example only describes how to configure link aggregation on AC A. To achieve link aggregation,
do the same on AC B.

1) In manual aggregation approach

# Create manual aggregation group 1.

system-view

[AC A] link-aggregation group 1 mode manual

# Add ports GigabitEthernet 0/0/1 through GigabitEthernet 0/0/3 to the group.

[AC A] interface GigabitEthernet 0/0/1

[AC A-GigabitEthernet0/0/1] port link-aggregation group 1

[AC A-GigabitEthernet0/0/1] interface GigabitEthernet 0/0/2

[AC A-GigabitEthernet0/0/2] port link-aggregation group 1

[AC A-GigabitEthernet0/0/2] interface GigabitEthernet 0/0/3

[AC A-GigabitEthernet0/0/3] port link-aggregation group 1

2) In static aggregation approach

# Create static aggregation group 1.