Adobe Premiere Pro CS6 - Manual (Page 89)

To the top
DV/HDV setup
A. Computer and computer monitor B. 6-pin FireWire port and connector C. 4-pin FireWire port and connector D. DV/HDV camcorder E. RCA
jacks and plugs for L (white) audio, R (red) audio, composite video (yellow); jack and plug for S-Video (y/c) F. HDMI port and
connector G. Television monitor
With this setup, you can capture audio and video from a DV or HDV source. You can monitor the signal on a TV monitor while editing. Finally, you
can export any sequence back to videotape.
1. Connect the DV or HDV camcorder or VTR to the computer using a FireWire cable.
2. Connect the camcorder or VTR to the television monitor with an S-Video or RCA video cable and RCA audio cables, or an HDMI cable.
3. Set the camcorder or VTR to VTR or Play mode.
4. (For HDV camcorders or VTRs only) Make sure the device is in DV playback mode for DV projects, or HDV playback mode for HDV
projects. See the user manual for your device for details.
Set up an SD-SDI, HD-SDI, or component system
SDI/component setup with breakout box
A. Computer and computer monitor B. (Optional) A/V breakout box C. XLR jacks and plugs for L & R audio D. RS232/422 port and
connector E. BNC jacks and plugs for Y/Pb/Pr component video, BNC jack, and plug for SDI video F. HD/SD VTR G. BNC jacks and plugs for
Y/Pb/Pr component video, BNC jack, and plug for SDI video H. RCA jacks and plugs for L (white) & R (red) audio I. Speakers J. Television
monitor
With this setup you can capture audio and video from an SD-SDI, HD-SDI, or component video device (camcorder or VTR). You can monitor the
signal on a TV monitor while editing. Finally, you can export any sequence back to the camcorder or VTR.
This setup requires either an SDI or component PCI card installed in the computer. Alternatively, it requires an external SDI or component device
connected to the computer via FireWire. Either an internal card or an external device would provide ports, usually with BNC connectors, capable of
receiving SDI or component video signals.
Some SDI and component PCI cards come with breakout boxes which provide ports for the SDI or component signals. Some breakout boxes also
provide ports for genlock. Others provide the necessary outputs directly on the card.
1. Connect the SD-SDI, HD-SDI, or component device to the computer or breakout box using SDI or component video cables. A single cable
with BNC connectors carries SDI video, but three separate cables with BNC connectors carry component video signals. Run video cables
85