Rockwell Automation 2092-DAx Ultra1500 User Manual - Manual (Page 75)

Publication 2092-UM001D-EN-P — July 2005
Commissioning Your Ultra1500 4-3
4. Look for the Ultra1500 icon (1.5k) under the On-Line Drives tree.
The Ultra1500 icon indicates that your drive is detected.
5. 5.Click on the [+] next to the Ultra1500 icon to expand the branch menu
(as indicated in the window above).
Configuring your Ultra1500
Drive This procedure assumes you have power applied to your drive and the drive is
detected by the Ultraware software.
Ultraware software provides a simple yet powerful way to configure your
Ultra1500 for a variety of applications. The Setup Wizard walks you through
configuration screens that prompt you to make selections when appropriate.
Typically, few adjustments are needed after using the Setup Wizard.
Note: In some applications, additional configuration may be necessary using
the Ultraware properties setup screens.
To configure your Ultra1500 drive:
1. Start Ultraware software and allow it to detect the Ultra1500 drive.
If your Ultra3000 drive: Then:
Is detected and listed under
the On-Line Drives tree
The software and hardware are communicating and the system is
ready.
Go to the section Configuring your Ultra1500 Drive.
Is not detected Check your serial cable, and then repeat steps 1 through 5.