Rockwell Automation 2092-DAx Ultra1500 User Manual - Manual (Page 73)

1 Publication 2092-UM001D-EN-P — July 2005
Chapter
4
Commissioning Your Ultra1500
This chapter describes how to configure you Ultra1500 drive using Ultraware
software. The chapter includes these sections:
• Applying Power to Your Ultra1500 Drive
• Detecting Your Ultra1500 Drive
• Configuring your Ultra1500 Drive
• Testing Your Motor
Applying Power to Your
Ultra1500 Drive This procedure assumes that you have:
• wired your Ultra1500 system,
• verified the wiring, and
• are ready to begin using the Ultraware software.
To apply power to your Ultra1500 drive:
1. Disconnect any load to the motor.
2. Apply main and control input power to the Ultra1500, and observe the
Operator Interface on the front of the drive. The drive should enter a
normal startup, as outlined below and shown in Figure 4.1.
IMPORTANT
Ensure the motor is free of all linkages when initially
applying power to the system.
If the Main Power,
and Control Power
LEDs are:
Then:
ON Go to step 3.
OFF Check your input power connections and repeat step 2, above.