Rockwell Automation 2092-DAx Ultra1500 User Manual - Manual (Page 166)

Publication 2092-UM001D-EN-P — July 2005
D-2 Ultra1500 Operator Interface
The following briefly explains the MODE/SET, ENTER, and directional keys
and their use.
Mode Displays Function Mode
The Function mode displays fourteen drive functions, although four functions
have restricted access. To perform an non-reserved drive function:
1. Enter the Function mode by pressing the MODE key.
The display indicates the selected Function by displaying
(where nn is a function number from the table below).
Key Name Function Example
SET
Saves the current value of the setting in
memory. To save any change:
• Press and hold SET until the display blinks.
MODE
Toggles the display between the four modes.
NOTE: The Status mode is the default display at
power-up.
To advance the display through the various mode
displays:
1. Press MODE to advance from the Status
mode (default display) to Set Parameter
mode,
2. Press MODE again to advance to Monitor
mode.
3. Press MODE again to advance to the
Function mode.
4. Press MODE once more to return to the
Status mode.
ENTER
Enter or exit a display containing the settings for
the selected mode.
NOTE: Before exiting the display, SET must be
pressed and held until the display blinks to save
any modified value to memory.
To access the settings for Pr-0.00 from the
Status mode:
1. Press MODE to advance to the initial
Parameter display (PR-0.00).
2. Then press ENTER to access the parameter's
value (01 is the default setting).
UP
Increments the value to a larger integer.
A non-functional key in the Status mode.
In any Parameter Setting, Monitor, or Function
mode:
• Press and hold the UP key to scroll to the
maximum value.
DOWN
Decrements the value to a smaller integer.
A non-functional key in the Status mode.
In any Parameter Setting, Monitor, or Function
mode:
• Press and hold the DOWN key to scroll to the
minimum value.
LEFT
Shifts the active digit to the left.
An invalid key for the Status mode.
In the Set Parameter mode:
1. Press LEFT to move from least to the most
significant digit in parameters
(PR-x.xX to PR-x.Xx.
2. Press LEFT again to move to the groups digit
(PR-X.xx).
RIGHT
Shifts the active digit to the right.
An invalid key for the Status mode.
In the Set Parameter mode:
1. Press RIGHT to move from least significant
digit in parameters to the groups digit
(PR-x.xX to PR-X.xx).
2. Press RIGHT again to move to the most
significant digit in Parameters (Pr-x.Xx).