Cabletron Systems 1800 - Manual (Page 96)

8-4 SmartSwitch 1800 4. 0 User G uide, Rev 01
Pressing [G] will display a list of all CUGs configured for this port, along with their
associated indices.
Configuring a Network Trunk
A network trunk is a link between SmartSwitch 1800/FRM/FRX nodes, over X.25.
Other ports in the node can be assigned to a "trunk group," which will cause those
ports to be disabled if the network trunk is not operational (and enabled when the trunk
becomes operational). One network trunk in a node can be assigned to another
network trunk's group; however, disabling/enabling a network trunk will not affect
another network trunk in that trunk's group.
Figure 8-3 X.25 Port Trunk Parameters
If Network Trunk is N , the rest of the above screen has no relevance.
You can add or delete one or more ports as described in menu entries B–E in Figure
8-3. To add or delete a range of sequentially numbered ports of the same port type,
press
[D] or [E] and enter (when prompted) the port type, first port, and last port. The
screen will be re-displayed, with the Y/N status changed for each affected port.
Adding or deleting a range has no affect on any port types within that range
other than the type specified.
To add or delete a single port, multiple ports that are not in sequence, or multiple ports
of different types, press
[B] or [C] and enter a port number. The screen will be re-dis-
played, with the Y/N status changed for the port. Repeat this process for each port you
want to add or delete.
Nod e Name=nod exyz
X.25 Port Parameters (s creen 5 of 6)
* RLP: 0
Port: 1 Link State: Lin kup
* I/O: UNI VERS AL
Databas e
A N etw ork Trun k Y
B A dd to Trun k Group
C D elete from Trunk Group
D A dd a R ange to Tru nk Grou p
E D elete a R ange from Trun k Group
Ports A ssociated with Network Tru nk
0 1 2 3
N N N N
Option: