Cabletron Systems 1800 - Manual (Page 303)

St atus Displays 20-5
● RLP – is always 0 , except for a remote control, file transfer, or alarm connection,
in which case this number is always 253 .
● P – is the port number ( 0-7 are physical ports, 8–63 are logical ports), unless RLP
is 253 , in which case: 66 = Remote control, 67 = File transfer, 68 = Alarm con-
nection.
Figure 20-4 Virtual Connections Display on Non-Frame Relay Port
[C],[C] from Main Menu
Information in this Display:
● Seq – is a sequence number used to identify the connection.
● I – is the logical interface: P = PVC, S = SVC
● D – is the direction of the connection: I = Incoming, O = Outgoing.
● LCN – is the logical channel number.
● State : Data_trans – means that call processing was successful and the con-
nection is in the data transmission state.
Call_setup – means that the attached device is waiting for Call Accept.
Clearing – means that the attached device is in Call Clear state, waiting
for Clear Confirmation.
Resetting – means that a Reset has been sent to the remote device, and the
attached device is waiting for a Reset Confirmation.
Port_down – is self-explanatory.
Connected – means that a connection has been established.
Not_conect – means that a connection has not been established or has
been broken.
Undefined – means that the port is in some unknown state.
● Subscriber – identifies the Calling Address of each end of the connection.
Node Name=nod e_xyz
Con nection Statu s D is play Menu (Page 1) RLP: 0 Port: 0
From: To:
Seq I D LC N State S ubs criber R LP P LCN S tate S ubs criber
1 S O 4095 Data_trans 100000100 0 0 4095 D ata_tran s 120000110
2 S I 500 Data_trans 1100001000 0 5 10 D ata_tran s 111000120
3 P I 255 Port_dow n 0 3 0 N ot_con ect
4 S I 10 Data_trans 110010000 253 3 6 D ata_tran s 33333