Cabletron Systems 1800 - Manual (Page 61)

Chapter 5
Loading Protocols
Although a SmartSwitch 1800 is shipped with a set of protocols already installed, a
file must be configured to properly load them into the software.
To access Protocol configuration, press [A] , then [B] from the Main Menu. Then:
●
To display a list of configured and loaded protocols, press [A] . A newly added
protocol is displayed as Configured until the node is rebooted, at which time the
protocol will be displayed as Loaded .
X.25 is always loaded, and will not be displayed. The information is
taken from the configuration file, which does not allow configuring
X.25. This prevents the possiblility of deleting X.25, which is a nec-
essary protocol for use by internal SmartSwitch 1800 traffic.
●
To display a table of memory usage, press [C] . This information, in conjuction
with information in the release notes, can help in planning the number of pro-
tocols to run.
●
To add or remove a protocol, press [B] . This will display a screen similar to
Figure 5-1.
Figure 5-1 Protocol Configuration Menu
[A],[B],[B] from Main Menu
The parameters RLP , Status , RLP Type , and Line Interface Card 1/2 are irrel-
evant, and are displayed only because some of the SmartSwitch 1800
software code is shared with the FRX6000, which uses the information.
N ode N ame= nodexyz
RLP Con figu ration
* RLP: 1 * S tatus: I nstalled * Memory C onfiguration : 8 Meg
* RLP Typ e: R LP
* Line In terface Card 1: UNI VERS AL
* Line In terface Card 2: VOICE
C onfigured Load ed
F Protocol 1: FR FR
G Protocol 2: I P I P
H Protocol 3: V OI CE V OI CE
I Protocol 4: S DLC S DLC
J Protocol 5: BS CI BS CI
K Protocol 6: N one
L Protocol 7: N one
M Protocol 8: N one
N Protocol 9: N one
Op tion :