Cabletron Systems 1800 - Manual (Page 221)

Configuring IP Routing 14-5
Figure 14-2 IP Interface Record – Frame Relay Example
[A],[C], [E],[B] from Main Menu
Destination IP Address is displayed only if Enable Inverse ARP is N .
Source IP Address is displayed only if Unnumbered Interface is N .
Some changes to IP Interfaces and Static Routes (described later) require
an extra step to update the SmartSwitch software. Changing certain param-
eters will generate the message:
Dynamic Routing Parameters have
changed. ............. Do you wish to update them at this time Y/N (N)? This must
be done, but if you are making several changes to IP Interfaces and Static
Routes, you can save time by specifying
N for each change until the final
one. Entering Y after the final change will update all changes made to both
IP Interfaces and Static Routes.
If you forget to specify Y after the last change, you can still update the
SmartSwitch 1800 via On-line Update Dynamic Routing Parameters , [G] at
the IP/LLC2/BRIDGE/IPX Defaults Configuration menu (or [A], [A], [E],
[G] from the Main Menu).
If the Interface Type is Ethernet , 802.3 , or 802.5 , there will be a menu item called Con-
figure Secondary Addresses . Selecting this item will display a screen similar to the
following.
N ode Name=n odexyz
I P In terface Configuration
* Interface Numb er: 10
A Maximum Transmiss ion Un it 4096
B Routing Metric Coun t 0
C ICMP R ed irects Y
D RIP Sup port 0 En abled
E RIP Flash Up dates (sec) 60
F RIP Fu ll U pdates (sec) 120
G Priority 5
H Bandw id th Allocation Group 1
I Interface Type FRL
J Source Card 0
K Source Port 0
L Source DLC I 16
M Enable I nvers e ARP N
N Destination IP Ad dres s 100.100.2.1
O Unn umbered I nterface N
P Source IP A ddress 100.100.2.2
Q Network Mas k 255.0.0.0
Option: