Configuring bridge ports, Configuring bridge ports -12, Bridge ports display -12 – Cabletron Systems 1800 User Manual
Page 264: Bridge ports, If creating a new record, press
16-12
SmartSwitch 1800 4. 0 User G uide, Rev 01
Configuring Bridge Ports
A Bridge port is a SmartSwitch 1800 LAN interface or frame relay port that will
operate as a bridge connection to the LAN or WAN.
Press
[C]
at the IP/LLC2/BRIDGE/IPX Interfaces Configuration Menu to display con-
figured Bridge ports.
Figure 16-4 Bridge Ports Display
[A],[C],[E],[C]
from Main Menu
These interfaces can be used for either LLC2 or Bridging. Also note
that the
RLP
column is irrelevant on the SmartSwitch 1800.
To configure an interface, press
[D]
at the IP/LLC2/BRIDGE/IPX Interfaces Config-
uration Menu. When prompted for an
Interface Number
(which is merely a sequential
number to identify the interface):
●
If modifying an existing record, enter the interface number:
0–95
.
Do not configure more than one interface per DLCI on a port.
●
If creating a new record, press
[Enter]
, which will automatically specify the next
available sequential interface number.
The display depends on the interface; the following figure shows an example, and
lists the parameters for all interface types.
Node N ame= nod e_xyz
Review Brid ge Ports/LLC2 In terfaces
-------------------------------------------------------------------------------------------------------
In terface Numb er
Type
RLP
Port
DLC I
Format
-------------------------------------------------------------------------------------------------------
0
Ethernet
1
Frame Relay
0
1
30
Native LLC-2
2
Frame Relay
0
1
31
8025_SRB
3
Frame Relay
0
1
32
8025_SRB
4
Frame Relay
0
1
33
8023_TB
PgUp, PgD n, F3:Exit, F9:Stop Remote, F10:Ab ort