Cabletron Systems 1800 - Manual (Page 79)

FRM Conf iguring Frame Relay 7-11
The first line of parameters applies to all DLCIs on the port (or in the node if [F2] is
pressed). The second line exists only for DLCIs configured as primary DLCIs in
backup configurations. In the example in Figure 7-5, DLCI 50 is a primary. All the
parameters are listed in
Table 7-4 (on page 7-15).
The parameters in the first line are:
● Port , DLCI are self-explanatory.
● ICIR = Committed Information Rate (In)
● IBC = Committed Burst Size (In)
● IBE = Excess Burst Size (In)
● OCIR = Committed Information Rate (Out)
● OBC = Committed Burst Size (Out)
● OBE = Excess Burst Size (Out)
● BECN = BECN Recovery Count
● Pri = Outgoing DLCI Priority
● Proto = Enable BackupProtocol
The parameters in the second line are:
● Grp = Backup Group Number
● RRLP = Remote RLP
● RPrt = Remote Port
● RDLCI = Remote DLCI
● SOT = Switchover Timer
● SBT = Switchback Timer
● TTH = Time to Hold Data While Waiting