Cabletron Systems 1800 - Manual (Page 301)

St atus Displays 20-3
Disabled – The link has been broken by the Disable Port operation (at the On-
Line Control menu).
Disconnect – For X.25, level 1 is up but level 2 cannot be established. For
SNA HPAD, no XID or SNRM command frame has been received for any
link address configured for the HPAD subscriber.
Configured – The port is configured in the database, but has been disabled.
Dial Ready – The X.25 dial port is ready to transmit or receive calls.
Quiesced – The port has been quiesced (described on page 19-12 ).
Failed – Some modem controls are not present, and the physical link is down.
● State for Voice ports:
Configured – The port is configured in the database, but has been disabled.
On Hook – Self-explanatory.
Dialing – Self-explanatory.
Wait on Accept – The number has been dialed, but the device at the remote
end has not yet established a connection.
Call Active – A call has been placed and answered
Pnd. on Hook – The device at the remote end has been placed on hook while
the call was in progress.
Failed – The physical link is down.
Displaying Virtual Connections
To display all physical and logical connections on a physical port, press [C] at the
Status Displays Menu and, when prompted, enter an RLP port number: 0–3 .
The display will differ depending on whether or not the port is a frame relay port.
Figure 20-3 shows a frame relay port and Figure 20-4 shows a non-frame relay port.