Node defaults parameters, Node defaults parameters -3, Of that device will be displayed as the local – Cabletron Systems 1800 User Manual
Page 53
Configuring Node Defaults
4-3
Node Defaults Parameters
The parameters on the first two Node Defaults screens are listed in Table 4-1, and the
NetView parameters on the third screen are listed in
(on page 4-6). Descrip-
tions of most parameters follow each table.
1
Remember that the software sees uppercase as different from lowercase.
2
A value of
0
means that no status will be sent.
3
If
0
, the connection will remain active continuously.
4
Continuous retries until connection is established.
Node Name
is displayed at the upper right of the screen when the device is being controlled by the
"local" keyboard and monitor. (If the local operator is controlling a remote Cabletron
frame relay access device, the
Remote Control ID
of that device will be displayed as the
local
Node Name
.)
Remote Control ID
is required if a remote Cabletron frame relay access device or async terminal will be
used to take control of the local SmartSwitch 1800 (via a physical or logical port in
the local device). The ID will be checked against the called address fields of incoming
Call Requests. The remote device can be a terminal connected to an async PAD port
on a remote Cabletron frame relay access device, or the remote device itself.
Table 4-1 Node Defaults Parameters
Parameter
Valid Values
Default Value
up to 8 characters
none
0–15 digits
none
0–15 characters
1
remote
0–15 digits
none
0–15 characters
1
ftran
0–15 digits
none
0–15 characters
1
al arms
1–15-digit address
none
0–15 characters
1
al arms
1–15-digit address
none
0–15 characters
1
al arms
Y/ N
N
1–50
(%)
50
1–50
(%)
25
0–30
(min)
2
1
0–65535
(sec)
0
3
5–3600
(sec)
60
0–99
0
(no max)
4