Cabletron Systems 1800 - Manual (Page 144)

9-18 SmartSwitch 1800 4. 0 User G uide, Rev 01
Figure 9-5 LLC2 Defaults Configuration Screen
[A], [A],[E],[B ] from Main Menu
Only item A applies to LLC2. Leave the remaining parameters at their
default values.
Configuring LLC2 Hosts
Each SNA/LLC2 host device that will connect to a SmartSwitch 1800 running LLC2
must be configured in the database.
To display any LLC2 hosts already configured for this node, press [C] at the Configure
IP/LLC2/BRIDGE/IPX Default Parameters Menu (or [A], [A], [E], [C] from the Main
Menu). This will list the hosts' MAC addresses and identify each LLC2 session as
Originated or Terminated . (In an Originated session, the host initiates LLC2 sessions;
in a Terminated session, the host accepts sessions destined for the address.)
A host-to-terminal connection is always initiated by the terminal.
To configure a host, press [D] at the Configure IP/LLC2/BRIDGE/IPX Default Param-
eters Menu. When prompted, enter:
●
Host Number: 0–128 . (Default is 0 .)
●
Any other requested information (if this is a new host), noting Table 9-4 (on
page 9-21).The resulting display will depend on the configured session type:
Figure 9-6 = Originated, Figure 9-7 = Terminated.
N ode Name=n odexyz
C onfigure Brid ge/LLC2 Node Defaults
A Virtu al LAN ID 000
B Bridge Enabled N
C Bridge Hello Time 2
D Bridge Max Age 20
E Bridge Forward Delay 15
F Bridge Aging Timer (seconds ) 300
G Bridge Priority 0
H Max Size Bridge Forwarding Table 65535
I IP Bridging En abled N
J IPX Bridging Enabled N
K SRB ID 0
L Default Eth ernet Frame Type Type II
Option: