Cabletron Systems 1800 - Manual (Page 206)

13-8 SmartSwitch 1800 4. 0 User G uide, Rev 01
Configuring Voice Ports
To configure a Voice port, press [D] at the Voice Configuration Menu (or [A], [C], [D]
from the Main Menu. When prompted for a Port Number , enter 4 or 5 .
Figure 13-4 Voice Ports
The display for an existing port will show the configured parameter values, while the
display for a new port will show default database values. (See
Table 13-4 .) The fol-
lowing figure is an example of an existing port.
Figure 13-5 Voice Port Screen 1
[A],[F],[D] from Main Menu
After making any changes, be sure to press [F7] to update the
system memory. Otherwise, the changes will not take effect until
the next re-boot of the SmartSwitch 1800.
Pressing [J] will display a second screen (from which two more screens can be dis-
played). The parameters for all screens are listed in Table 13-4 .
Voice 1 (Port 4)
Voice 2 (Port 5)
Nod e Name=nod e_xyz
Voice Port Configuration Parameters (screen 1 of 2)
*
Port: 4 Link State: Lin kup
* I /O: VOIC E Datab ase System Memory
* Port Typ e VOIC E
* Phys ical Port In terface RJ45
A Blocked Port Flag N N
B R ate 8 8
C D TMF Detection 1 1
D Timed E Timer 3 3
E I npu t Level 0 0
F Outp ut Level -4 -4
G I n Hu nt Group No No
H S LT Time-out 30 30
I Link D own Busy Y Y
J A dditional Parameters
Option: