Cabletron Systems 1800 - Manual (Page 51)

Chapter 4
Configuring Node Defaults
Node Defaults are a set of parameters that identify a SmartSwitch 1800 for purposes
of remote control, software updates, file transfers, and/or alarm reporting to or from
other Cabletron frame relay access devices (SmartSwitch 1800, 9W004, FRX4000,
FRX6000), and define connections between the SmartSwitch 1800 and a NetView
manager device.
Press [C] at the Node Configuration Menu to display a screen similar to Figure 4-1.
This is the first of three Node Defaults screens—pressing [PgDn] or [PgUp] will change
the display among the three screens.
The first two screens contain parameters that apply to all users. The third screen con-
tains parameters used in sessions between a NetView host and the NetView service
point function in the SmartSwitch 1800. If the NetView function will not be used, the
third screen does not have to be configured.
Figure 4-1 Node Defaults Configuration Screen 1
[A],[A],[C] from Main Menu
After making any changes, be sure to press [F7] to update the
system memory. Otherwise, the changes will not take effect until
the next re-boot of the SmartSwitch 1800.
N ode Name=n ode_xyz
N ode D efau lts Con figu ration (Screen 1 of 3)
D atabase Sys tem Memory
A Node Name n ode_xyz nod e_xyz
B Remote Con trol I D
C Remote Con trol Pwd
D File Transfer ID
E File Transfer Pwd
F Collectin g S martS witch ID
G Collectin g S martS witch Pwd
H Primary Alarm Outpu t I D
I
Primary Alarm Outpu t Pwd
J Secon dary A larm Outp ut ID
K Secon dary A larm Outp ut Pw d
Option: