Configuring bridge filters, Configuring filter definitions, Configuring bridge filters -6 – Cabletron Systems 1800 User Manual
Page 258: Configuring filter definitions -6, Review bridge filter definitions, Configure bridge filter definitions
16-6
SmartSwitch 1800 4. 0 User G uide, Rev 01
Configuring Bridge Filters
Filtering is the method by which the network manager controls usage of an inter-
network. A filter permits or denies (depending on how it is configured) some or all of
a specific type of bridged traffic across an interface. This can be helpful in such ways
as limiting unwanted or inappropraite traffic onto LANs or WANs, or preventing
access to certain devices for security purposes.
The process of configuring and using Bridge filters is as follows. Both procedures are
described later in this chapter.
1. Create a Bridge Filter Definition record.
2. Create a Bridge Filter Applications record, which will determine how the filter
definitions will be applied.
3. Perform an on-line update of the definitions and applications (described under
Configuring Bridge Filter Applications
" on page 16-10). To review existing
filters, press
[F]
at the Filter Definitions and Applications Configuration Menu (or
[A], [A], [E], [F], [F]
from the Main Menu).
Configuring Filter Definitions
To define a filter, press
[G]
at the Configure Filter Definitions and Applications Menu.
When prompted, enter:
●
Filter Type
:
4
= Generic
5
= MAC (Default)
6
= LLC2 SAP
7
= Protocol
8
= Bridged native NetBIOS.
●
Filter ID
:
1–65535
. (The default is
1
.) This is simply a unique identifier.
●
Any other requested information, noting the values in
(on page 16-10). (Press
[Enter]
at a prompt to accept a
default value.)
The display will depend on the filter category. The following figure shows an example
of a MAC filter record.