Configuring static ipx routes, Configuring static ipx routes -16, Review ipx routing – Cabletron Systems 1800 User Manual
Page 248: Configure ipx routing, Svc idl e timer, Max vcs to establish, Pvc connection, Lan card number
15-16
SmartSwitch 1800 4. 0 User G uide, Rev 01
SVC Idle Timer
is a period that an IPX connection can remain active with no traffic before the con-
nection is cleared.
Max VCs to Establish
specifies a number of virtual circuits over which IPX traffic will be transmitted in par-
allel.
PVC Connection
identifies this interface as one end of a PVC.
Descriptions of Parameters Specific to LAN Interfaces
LAN Card Number
identifies the interface number as
0
. There is no LAN card, but the software code is
shared with the Netlink FRX6000, which does have a card.
Configuring Static IPX Routes
Routing of IPX traffic is handled dynamically by such protocols as RIP and SAP, as
well as via static routes configured in the SmartSwitch 1800.
To display configured static routes, press
[H]
at the Connections and Routing Paths
Menu (or
[A], [D], [H]
from the Main Menu).
To configure a route, press
[I]
at the Connections and Routing Paths Menu. When
prompted, enter:
●
Type
:
0
(RIP) or
1
(SAP). (The default is
0
.)
●
Route/Service Number
:
0–65535
. (The default is
0
.). This is simply an identifier.
The display will be similar to the RIP example in the following figure. (A SAP record
will display different parameters.)