Cabletron Systems 1800 User Manual
Page 10
x
SmartSwitch 1800 4. 0 User G uide, Rev 01
IP Addressing................................................................................... 14-1
Using the Node as an IP Gateway ................................................... 14-2
Required Configuration ................................................................... 14-3
Configuring IP Node Defaults................................................................ 14-3
IP Node Defaults Parameters........................................................... 14-4
IP Interface Parameters.................................................................... 14-7
Configuring Static IP Routes................................................................ 14-14
IP Routing Parameters................................................................... 14-15
Required Configuration ................................................................... 15-1
Configuring IPX Node Defaults............................................................. 15-2
IPX Node Defaults Parameters........................................................ 15-2
Configuring IPX Filter Definitions.................................................. 15-3
Configuring IPX Filter Applications............................................... 15-8
IPX Filter Applications Parameters................................................. 15-9
Configuring IPX Interfaces .................................................................... 15-9
IPX Interface Parameters............................................................... 15-10
Parameter Descriptions.................................................................. 15-13
Configuring Static IPX Routes............................................................. 15-16
IPX RIP Static Route Parameters .................................................. 15-17
IPX SAP Static Route Parameters................................................. 15-18
Required Configuration ................................................................... 16-2
Configuring Default Node-Wide Bridging Parameters.......................... 16-3
Bridge Node Default Parameters..................................................... 16-4
Configuring Filter Definitions ......................................................... 16-6
How Filter Masks Work .................................................................. 16-7
Configuring Bridge Filter Applications......................................... 16-10
Bridge Filter Application Parameters............................................ 16-11
Configuring Bridge Ports..................................................................... 16-12
Bridge Port Parameters.................................................................. 16-13
Configuring SNMP System Defaults ..................................................... 17-1
System Defaults Parameters ............................................................ 17-2
Configuring a Community Table ........................................................... 17-2
Community Table Parameters ......................................................... 17-3
Configuring Trap Routing...................................................................... 17-4
Trap Routing Parameters ................................................................. 17-4