Cabletron Systems 1800 - Manual (Page 241)

Configuring IPX 15-9
IPX Filter Applications Parameters
Permit
Determines whether the traffic defined by the Filter "n" entries will be permitted or
denied passage across the interface.
Filter "n"
corresponds to the Filter ID s in the IPX Filter Definitions file. (See page 15-3.)
Configuring IPX Interfaces
An IPX interface allows a SmartSwitch 1800 to connect to a Novell IPX network.
Press
[E] at the IP/LLC2/BRIDGE/IPX Interfaces Configuration Menu (or [A], [C], [E],
[E] from the Main Menu) to display configured IPX interfaces.
To configure an interface, press [F] at the IP/LLC2/BRIDGE/IPX Interfaces Configu-
ration Menu. When prompted, enter an Interface Number : 0–63 . (This is merely a
sequential number to identify the interface.)
The display depends on the interface; the following figure shows an example, and
Table 15-7 through Table 15-9 list the parameters for all interface types.
Figure 15-4 IPX Interface Record Example
[A],[C], [E],[F] from Main Menu
Table 15-6 IPX Filter Applications Parameters
Parameter Valid Values Default Value
Permit Y/ N N
Fi lter "n" 0–65535 0
IPX Interface C onfiguration
* In terface Nu mber 2
A Block ed Port Flag N
B In terface Type Ethern et
C Frame Type TYPE_II
D Maximu m Trans mis sion U nit 4096
E IPX Network Add ress 00000001
F Priority 0
G Band width Allocation Group 1
H Port Diagnos tics Enabled Y
I NetBIOS Enab led N
J NetBIOS Hops 8
K Periodic RI P Enabled Y
L Periodic RI P Timer (s ec) 60
M Periodic SA P Enabled Y
N Periodic SA P Timer (s ec) 60
O Ad dition al IPX Parameters
Op tion :