Sna port pu parameters -7, Table 9-2, Port type – Cabletron Systems 1800 User Manual
Page 133: Name
Configuring SNA
9-7
1
Set
Autocall
to
Y
for TPADs and
N
for HPADs.
2
If the PU will be used for SDLC-LLC2 conversion (at the local node, or at a remote node
via a logical or physical X.25 port), this must be
Y
.
3
In multiples of 4.
4
In Token Ring format.
5
Will override the value configured for the same parameter in the Node Defaults file, with
two exceptions—if
0
is configured in Port Configuration for
Priori ty
or
Bandwidth Al lo-
cation G roup
, the value in Node Defaults will apply.
6
Must be less than the value for
T1
to ensure that the remote link station will receive the
delayed acknowledgment before
T1
expires.
Port Type
specifies the protocol the port will support. Selecting this parameter will display a list
of all serial protocols loaded in the device.
Name
is used to identify the port to some manager devices.
Table 9-2 SNA Port PU Parameters
Parameter
Valid Values
Default Value
up to 10 characters
none
0–15 characters
none
0–15 characters
none
(Max I-Frm bytes/ frame)
25–4105
265
Y/ N
1
N
(sec)
15–255
60
0–255
0
(indefinite)
Active, I nactive
Acti ve
0–255
0
Y/ N
2
N
Two-way Alternate,
Two-way Si multaneous
Two-way Al ternate
LLC2 Parameters
0–fc
(hex)
3
04
0–ffffffffffff
4
000000000000
0–fff
000
0–fffff
00000
(100 msec)
5
0–250
10
(msec)
5
100–5000
6
100
(sec)
5
1–50
30
5
1–127
1
5
1–127
1
5
0–255
8
5
0–9
0
5
0–16
0
Y/ N
N