Cabletron Systems 1800 - Manual (Page 164)

10-8 SmartSwitch 1800 4. 0 User G uide, Rev 01
Configuring Subscriber Addresses
This operation configures the called and calling addresses that will be used in call
setup. To complete the connection, the software must recognize where the call is
coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press [A] at the Connections and
Routing Paths Menu (or [A], [D], [A] from the Main Menu).
To add or change a Subscriber ID, press [B] at the Connections and Routing Paths
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on
page 8-21 .)
Figure 10-3 Typical SVC Subscriber Screen
[A],[D],[B] from Main Menu
Pressing [G] will display routing paths, which link the subscriber with one or more
ports. Pressing [H] will display the addresses used for call redirection. (These
addresses are valid only if Y is specified for one or more of items C, D, and E on the
first screen.) Parameters for all three screens are described following Table 10-3 .
Subscriber Parameters
Table 10-3 SVC Subscriber Parameters
Parameter Valid Values Default Value
Subscriber Name 0–31 characters none
Routi ng Al gori thm 0–3 0
System atic Redirection Y/N N
Nod e Name=nod exyz
SV C Sub scriber Main ten ance
*
S ubs criber ID 0100012345
A S ubs criber Name su b1
B R outing Algorithm 0, Rou nd Robin
C S ystematic Redirection N
D R ed irect on Busy N
E R ed irect on Ou t of Order N
F C onnection Priority 0
G R outing Path s
H R ed irection Ad dres ses
Option: