Cabletron Systems 1800 - Manual (Page 348)

21-22 SmartSwitch 1800 4. 0 User G uide, Rev 01
● Pkts Tx – is the total number of RIP and SAP packets transmitted on the local
interface.
● Tx Completions – is the total number of successfully transmitted RIP and SAP
packets that originated at the local node.
● Pkts Rcv – is the total number of RIP and SAP packets received on the local
interface.
● Tx Pkts Filtered – is the number of packets denied transmission because of a
filter configured on the interface.
● Rcv Pkts Filtered – is the number of packets denied reception because of a filter
configured on the interface.
● Pkts Forwarded – is self-explanatory.
● Echo Requests Rcv – is the number of Echo Requests received on the interface.
● Echo Replies Rcv – is the number of replies to Echo Requests received on the
interface.
● Err_Type Pkts Rcv – is the number of Novell error packets received on the
interface.
● Pkts Discarded – is the number of packets discarded because the interface was
down.
● Pkts_2_Large Rcv – is the number of packets received that exceeded the
Maximum Transmission Units configured for the interface. These packets are
discarded.
● Major/Minor Version – are the version numbers of the IPX stack.
● Rcv Header Error – is the number of IPX packets received with incorrect header
information. The header should be 30 bytes and contain network, node, and
socket addresses for source and destination.
● Ukn Sockets Rcv – is the number of socket numbers received that could not be
identified. Some socket numbers (assigned by Novell) are:
0451 = NCP Process 0452 = SAP Process
0453 = RIP Process 0455 = NetBIOS Process
0456 = Diagnostics Process
● Rcv BSys Discard through R_Decomp Errors – are not monitored by the FRX/
FRM, but are included in the statistics list because it is part of the IPX MIB. The
statistics in the list between the above two are:
Bad Checksum Rcv, Local Rcv
Pkts, Path_Not Found, Local Tx Pkts, Bad Local Tx Pkts, Tx BSys Discard, Open
Socket Fail, State Changes, Init Fail, Ms to Tx 1 Byte
● R-RIP Ent-Filter – is the number of received RIP entries discarded due to a filter.
● T-RIP Ent-Filter – is the number of transmitted RIP entries discarded due to a
filter.
● R-SAP Ent Filter – is the number of received SAP entries discarded due to a filter.
● T-SAP Ent-Filter – is the number of transmitted SAP entries discarded due to a
filter.
● R-RIP Pkt-Filter – is the number of received RIP packets discarded due to a RIP
router filter.
● T-RIP Pkt-Filter – is the number of transmitted RIP packets discarded due to a
RIP router filter.