Configuring subscriber ids, Configuring subscriber ids -21, Typical svc subscriber screen -21 – Cabletron Systems 1800 User Manual
Page 112: Review subscriber ids, Configure subscriber ids, Svc subscriber id(s)
8-20
SmartSwitch 1800 4. 0 User G uide, Rev 01
Configuring Subscriber IDs
This operation configures the called and calling addresses that will be used in call
setup. To complete the connection, the software must recognize where the call is
coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press
[A]
at the Connections and
Routing Paths Menu (or
[A]
,
[D]
,
[A]
from the Main Menu).
To add or change a Subscriber ID, press
[B]
at the Connections and Routing Paths
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on
Figure 8-6 Typical SVC Subscriber Screen
[A],[D],[B]
from Main Menu
If configuring an ID that will be a
Source Subscriber
on an IP (over X.25)
), accept the default values for all param-
eters after
Subscriber Name
, and do not configure any Routing Path. If con-
figuring an ID that will be a
Destination Subscriber
on an IP (over X.25)
Interface, accept the default values for all parameters after
Subscriber
Name
, except
1st Routing Path
, which must be configured as the node and
physical X.25 port that will be used as the interface.
Pressing
[G]
will display routing paths, which link the subscriber with one or more
ports. Pressing
[H]
will display the addresses used for call redirection. (These
addresses are valid only if
Y
is specified for one or more of items C, D, and E on the
first screen.) Parameters for all three screens are described following
Nod e Name=nod exyz
SV C Sub scriber Main ten ance
*
S ubs criber ID
0100012345
A
S ubs criber Name
su b1
B
R outing Algorithm
0, Rou nd Robin
C
S ystematic Redirection
N
D
R ed irect on Busy
N
E
R ed irect on Ou t of Order
N
F
C onnection Priority
0
G R outing Path s
H R ed irection Ad dres ses
Option: