Cabletron Systems 1800 - Manual (Page 255)

Configuring Bridging 16-3
Configuring Default Node-Wide Bridging Parameters
If one or more Bridge ports (interfaces) will be established in the local node, certain
parameters must be configured to define bridge operation. Press
[B] at the Configure
IP/LLC2/BRIDGE/IPX Default Parameters Menu (or [A], [A], [E], [B] from the Main
Menu). When prompted, enter:
● Virtual LAN ID – if also configuring LLC2 or Bridging in the node, enter a value
of 0–fff (hex). Otherwise, press [Enter] (accepting the default of 000 ).
LAN IDs can also be configured in LLC2 Interface/Bridge Port
records (later in this chapter). Each LAN ID must be unique
within the network on which this node will operate.
●
Any remaining requested information, referring to Table 16-1 .
Figure 16-1 Bridge Node Defaults Configuration Screen
[A],[A], [E],[B] from Main Menu
Node Name=nod e_xyz
Con figu re Bridge/LLC 2 N ode Defaults
A V irtual LAN ID 000
B Bridge En abled N
C Bridge Hello Time 2
D Bridge Max A ge 20
E Bridge Forward D elay 15
F Bridge A gin g Timer (s econd s) 300
G Bridge Priority 0
H Max Size Bridge Forw ard in g Tab le 65535
I I P Brid gin g Enab led N
J I PX Bridging En abled N
K S RB ID 0
L D efau lt Ethernet Frame Typ e Type I I
Option::