Cabletron Systems 1800 - Manual (Page 193)

Configuring Async Ports 12-15
Configuring Subscriber Addresses
This operation creates records for the called and calling addresses that will be used in
call setup. To complete the connection, the software must recognize where the call is
coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press [A] at the Connections and
Routing Paths Menu (or [A], [D], [A] from the Main Menu).
To add or change a Subscriber record, press [B] at the Connections and Routing Paths
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on
page 8-21 .
Figure 12-3 Typical SVC Subscriber Screen
[A],[D],[B] from Main Menu
Pressing [G] will display routing paths, which link the subscriber with one or more
ports. Pressing [H] will display the addresses used for call redirection. (These
addresses are valid only if Y is specified for one or more of items C, D, and E on the
first screen.) Parameters for all three screens are described following Table 12-4.
Node Name=nod exyz
SV C S ubs criber Main ten ance
*
S ubs criber ID 0100012345
A S ubs criber Name sub 1
B R outing Algorithm 0, Roun d Robin
C S ystematic R ed irection N
D R ed irect on Busy N
E R ed irect on Ou t of Order N
F C onnection Priority 0
G R outing Paths
H R ed irection Add ress es
Option: