Cabletron Systems 1800 - Manual (Page 47)

Introduction to Database Configuration 3-11
E On-Line Update IPX Filter Definitions and Applications –
(Chapter 15) allows updating the SmartSwitch with any changes
without rebooting.
F Review Bridge Filter Definitions – (Chapter 16) displays any
Bridge filters (see next item) that have been configured on the
SmartSwitch.
G Configure Bridge Filter Definitions – (Chapter 16) specifies
parameters for regulation of bridge traffic by filtering MAC
addresses, NetBIOS names, SAP updates, etc.
H Review Bridge Filter Applications – (Chapter 16) displays
information on any bridge filter applications (see below)
configured on the SmartSwitch.
I Configure Bridge Filter Applications – (Chapter 16) applies
bridge filters to interfaces/filter types/directions.
J On-Line Update Bridge Filter Definitions and Applications
(Chapter 16) allows updating the SmartSwitch with any changes
without rebooting.
G On-Line Update Dynamic Routing Parameters – (misc.) updates
the system memory with any changes that have been made to
routing parameters.
F Configure Async PAD Parameters – (Chapter 12) defines operating
parameters for devices connected to SmartSwitch async PAD ports.
A Review Async PAD Profiles
B Configure Async PAD Profiles
C Review Async PAD Logins
D Configure Async PAD Logins
G Review Model Information – displays the maximum number of
logical connections allowed, and lists the protocols installed, on the
SmartSwitch 1800.
H Configure Bandwidth Allocation Groups – (Chapter 4) defines up
to 16 groups that assign connection priorities to various types of
traffic.
B Configure Protocols (Chapter 5)
A Review Protocol Configuration – displays installed protocols.
B Configure Protocols – specifies the protocols that will be used.
C Display Memory Status – displays a table showing available and
used memory.
C Configure Ports
A
Configure RLP Ports – (Chapter 6 through Chapter 12) specifies types
and operating parameters of serial ports.
B Configure LAN Port – (Chapter 6) specifies the type (Ethernet or
Token Ring) and associated address for the LAN interface.
C X.25 Address Translation Templates – (Chapter 8) displays, specifies,
and tests templates that are applied to incoming and outgoing call
packets for the purpose of translating selected fields of a packet that may
not otherwise be in a compatible format.
A Review X.25 Address Translation Templates
B Configure X.25 Address Translation Templates
C Test X.25 Address Translation Templates
D Configure Logical Ports – (Chapter 8) specifies operating parameters
for logical ports residing on physical frame relay ports.