Configuring port statistics thresholds, Configuring port statistics thresholds -4, Physical x.25 port parameters -6 – Cabletron Systems 1800 User Manual
Page 330: Port, At the statistics menu. when prompted, enter, For port, Default
21-4
SmartSwitch 1800 4. 0 User G uide, Rev 01
Configuring Port Statistics Thresholds
For each port statistic, you can specify a threshold that, when crossed, causes an alarm
to be sent to the collecting node.
Press
[A]
at the Statistics Menu. When prompted, enter:
●
Statistic level
:
P
for Port.
●
Port
:
0–7
. Valid numbers for physical ports depend on the model of SmartSwitch
1800—see port locations on
.
A menu similar to the following figure will be displayed.
Figure 21-4 Port Statistics Configuration Menu
[E],[A]
from Main Menu
Changing a threshold changes the database value. Press
[F7]
to write the
change to system memory.
A threshold is either a number or a percentage, depending on the statistic. The valid
range for any statistic is
0–65535.
(Default =
0.
) When the measured value for the sta-
tistic crosses the threshold (in either direction), an alarm is generated.
N ode Name= node_xyz
Port S tatis tics (Thresholds )
RLP: 0
Port: 1
D atabase
S ystem Memory
A Received frames/Sec (*10)
0
0
B Transmitted frames/Sec (*10)
0
0
C Retran frames/Sec (*10)
0
0
D FCS errors /S ec (*10)
0
0
E Logical rejects/Sec (*10)
0
0
F Transmit error ratio
0
0
G Receive error ratio
0
0
H % R eceive port utilization
0
0
I
% Trans mit port u tilization
0
0
Op tion :