Cabletron Systems 1800 - Manual (Page 269)

Chapter 17
Configuring SNMP
The SNMP (Simple Network Management Protocol) agent allows a network man-
agement station using internet protocol to obtain information from Cabletron frame
relay access devices. Access to the agent is through any IP interface, including frame
relay or X.25 ports configured for IP, and LAN interfaces.
The agent handles get and (for some fields) set commands from the SNMP manager
to provide topology information and node status. This information is retrieved by
calling it from the Management Information Base (MIB).
The SmartSwitch 1800 supports parts of the Internet-standard MIB II (RFC 1213), as
well as the frame relay MIB (RFC 1315), the SDLC MIB (RFC 1747), the X.25 MIBs
(RFC 1381 and 1382), and a Cabletron-proprietary Netlink MIB. The tree structures
are shown in the MIB Reference Guide (part number 09-41-06-149), which is
available from Cabletron Systems.
Configuring SNMP System Defaults
SNMP system defaults identify the local agent to the SNMP manager. Press [A] at the
SNMP Configuration menu to display the following screen:
Figure 17-1 SNMP System Defaults Menu
[A],[A],[D],[A] from Main Menu
Node N ame= node_xyz
SN MP Defaults Menu
A Sys tem Name
B Sys tem Location
C Sys tem Con tact
Op tion ::