Chapter 22 system events, Configuration, Chapter 22 – Cabletron Systems 1800 User Manual
Page 349: System events, Configuration -1, Events, Chapter 22)
Chapter 22
System Events
SmartSwitch 1800 alarm, or event, messages can be displayed locally (see “
” on page 22-3), as well as sent to an async terminal, a serial or parallel
printer, another node, or any other device capable of interpreting event messages.
Events parameters are set in Node Defaults (
[A], [A], [C]
from the Main Menu). The
message file ERRMSG.TXT contains the format of events for message construction.
Configuration
To configure a SmartSwitch 1800 to collect events from other Cabletron frame relay
access devices (SmartSwitch 1800, FRM, FRX4000, FRX6000), do the following in
(described in Chapter 4):
to
Y
. (The default setting is
N
, so the parameter may have to
be reconfigured.)
according to the guidelines in
3. Specify a
and
(Password)
. (Keeping the
default password is recommended.) These will be used by other nodes to place a
call.
4. If you want this node to route all events (including its own) to another device
(such as a printer), specify a
(Password)
. (Keeping the default password is recommended.) Note that the
password serves no function if a printer is specified.
5. If you want this node to route all events to a second device as well as that defined
(Password)
. (Keeping the default password is recommended.)
At each node that will send its events to the collecting node:
to
N
(the factory default setting).
2. Specify the
and
(Password)
to
(Password)
of the col-
lecting node.
3. In the Port record for the physical or logical X.25 port that will be used for inter-
node connections, configure
Maximum LAPB Window Size
to match the same
parameter in the collecting node.