Cabletron Systems 1800 - Manual (Page 404)

C-12 SmartSwitch 1800 4. 0 User G uide, Rev 01
PTT/Telco Connectors and Cabling
Figure C-7 RJ45 Connector Pins
The RJ45 connector on a SmartSwitch 1800 is mainly used for E&M operation. An
RJ45 cable is included with each SmartSwitch 1800. The cable end with the connector
plugs into the SmartSwitch, and the end with bare wire connects to a telco/PTT type
punch block. The cable is color-coded as described in the following table.
The RJ45 cable can also be used to provide the two-wire connection. For these appli-
cations, only the red and green wires (pins 4 and 5) are active; the other wires should
be insulated with electrical tape to prevent unwanted connections.
Table C-1 RJ45 Cable Connections
Pin Color Usage Description
1 Gr ay SB Return for M Signal
2 Or ange M Control Signal from PBX
3 Black TR Voi ce from PBX (Transmit Ring)
4 Red RR Voi ce to PBX (Receive Ring) two-wi re connection
5 Gr een RT Voi ce to PBX (Receive Tip) two-w ire connecti on
6 Yel low TT Voi ce from PBX (Transmit Tip)
7 Blue E Control Signal to PBX
8 Brown SG Return for E Signal
SB
M
TR
RR RT
TT
E
SG
1 8