Cabletron Systems 1800 - Manual (Page 140)

9-14 SmartSwitch 1800 4. 0 User G uide, Rev 01
Configuring Subscriber Addresses
This operation configures the called and calling addresses that will be used for con-
necting to an LLC2 host, or in X.25 call setup if SNA is being transported over a
logical X.25 port. To complete the connection, the software must recognize where the
call is coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press [A] at the Connections and
Routing Paths Menu (or [A], [D], [A] from the Main Menu).
To add or change a Subscriber ID, press [B] at the Connections and Routing Paths
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on
page 8-21 .)
Figure 9-4 Typical SVC Subscriber Screen
[A],[D],[B] from Main Menu
Pressing [G] will display routing paths, which link the subscriber with one or more
ports. Pressing [H] will display the addresses used for call redirection. (These
addresses are valid only if Y is specified for one or more of items C, D, and E on the
first screen.) Parameters for all three screens are described following Table 9-3 .
N ode N ame= nodexyz
SVC Su bscrib er Maintenan ce
*
Su bscrib er I D 0100012345
A Su bscrib er N ame s ub1
B Rou tin g Algorith m 0, R ound R obin
C Sys tematic Redirection N
D Redirect on Bu sy N
E Redirect on Out of Order N
F Con nection Priority 0
G Rou tin g Paths
H Redirection A ddresses
Op tion :