Cabletron Systems 1800 - Manual (Page 234)

15-2 SmartSwitch 1800 4. 0 User G uide, Rev 01
Configuring IPX Node Defaults
Press [E] at the Configure IP/LLC2/BRIDGE/IPX Default Parameters Menu (or [A],
[A], [E], [E] from the Main Menu) to configure default IPX node parameters.
Figure 15-1 IPX Node Defaults Menu
[A],[A], [E], [E] from Main Menu
IPX Node Defaults Parameters
Internal Network
identifies the node to the IPX network. If fewer than 8 hex digits are entered, leading
zeros will be added.
Gap
is the minimum delay between consecutive RIP and SAP (Service Advertising Pro-
tocol) transmissions. This parameter provides compatibility with older Novell servers.
Router Name
is simply an identifier for the IPX network. It must be unique within the network.
Table 15-1 IPX Node Defaults Parameters
Parameter Valid Values Default Value
Internal Network 0–ffffffff (8 hex digits) 00000000
Gap (55 ms intervals) 0–100 1
Router Name 1–47 characters none
Node N ame= nodexyz
Con figu re IPX N ode D efau lts
A In ternal Network 0000001e
B Gap (55ms intervals ) 1
C Rou ter Name ip x_rou ter_1
Op tion :