Cabletron Systems 1800 - Manual (Page 207)

Configuring Voice 13-9
Voice Port Parameters
1 0 = disable, 1 = enable, 2–255 = number of seconds tone will be generated.
2 Valid only if Interface is E&M .
3 The number of digits used as an auto-dial number. ( The parameter Speed Map Dial
Di gits is configured in Voice System-Level Parameters.)
4 If you set Source of Extended Di gi ts to Map , the Dial Timer value will automatically be
Table 13-4 Voice Port Parameters
Parameter Valid Values Default Value
Bl ocked Port Flag Y/N N
Rate 4.8, 8, 32, 64 Kbps 8 Kbps
DTMF Detecti on 1–255 1 1
Ti med E Timer 0–255 (seconds) 2 3
Input Level see explanation 0 (dB)
Output Level see explanation -4 (dB)
In Hunt Group irrelevant—not currently supported N
SLT Time-out 1–99 (seconds) 30
Li nk Down Busy Y/N Y
Fax Supported Y/N Y
Telephony Interface Type OPX, SLT, E&M, AC15 O PX
Interface
Depends on setting of Telephony
Inter face Type —see explanation Loop Start
Jitter 10–255 (msec, in 5-ms increments) 80
Call Ti mer 1–30 (seconds) 5
Long Dial Pr efix see explanation * (asterisk)
Suppr ession 1–5 ( 1 = no suppression) 2
Auto Dial Parameters
Auto Dial Y/N N
Auto Dial Num ber
number of digits configured for
Speed Map Dial Digits 3 none
Auto Poll Y/N N
Auto Poll Timer 5–30 (seconds) 10
Enhanced Dialing Parameters
Di al Ti mer (sec) 0–10 ( 0 = no time limit) 0 4
Source of Extended Digits Map, User Map 4
# of Leading Digits to Delete 0–4 0
Forw ard Del ay 0–40 (0.25 sec increments) 2 (0.5 sec)
Forw arded Di gi t Type DTMF, Pul se DTMF
Forw arded Output Digits None, All, Ext None
Make/Break Ratio Make: 20–80 (in increments of 2)
Break: 80–20 (in increments of 2)
34
66
DTMF ON Duration 30–1000 ms 100
DTMF OFF Duration 30–1000 ms 100
Tone Type DTMF, MF DTMF