Configuring ipx filter applications, Configuring ipx filter applications -8, Typical ipx filter applications record -8 – Cabletron Systems 1800 User Manual
Page 240: Review ipx filter applications, Configure ipx filter applications, Configuring ipx filter application, Main menu). to configure an application, press, The default is, This identifies the virtual interface, Packet
15-8
SmartSwitch 1800 4. 0 User G uide, Rev 01
Configuring IPX Filter Applications
IPX Filter Applications determine how filters will be used at the interface. To review
existing applications, press
[C]
at the Configure Filter Definitions and Applications
Menu (or
[A], [A], [E], [F], [C]
from the
Main Menu). To configure an application, press
[D]
at the Configure Filter Definitions and Applications Menu. When prompted, enter:
●
Interface number:
0–63
. (The default is
0
.) This identifies the virtual interface.
●
Filter Category
:
0
= RIP,
1
= SAP,
2
= Packet,
3
= RIP Router. (The default is
0
.)
●
Direction
:
i
(inbound) or
o
(outbound). (The default is
o
.)
●
Any other requested information, referring to
Figure 15-3 Typical IPX Filter Applications Record
[A], [A],[E], [F],[D]
from Main Menu
Up to 100 filters can be configured, displayed over 9 "pages" (screens).
When finished configuring filter definitions and applications, perform an on-line
update to make the changes effective immediately. Press
[E]
at the Filter Definitions
and Applications Configuration Menu. The changes will be sent to the software.
IPX Filter App lication s
*
In terface Numb er
2
*
Filter Category
0 RI P
*
Direction
I –Inb ound
A Permit
Y
B Filter App lication 1
0
C Filter App lication 2
0
D Filter App lication 3
0
E Filter App lication 4
0
F Filter App lication 5
0
G Filter App lication 6
0
H Filter App lication 7
0
I
Filter App lication 8
0
J
Filter App lication 9
0
K Filter App lication 10
0
2
Page 2
Op tion :