Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 99)

Offset Table and Setup
Chapter 3
3-25
4. Use the up, or down cursor keys to move the block cursor to the
feedrate parameter to be changed. The selected feedrate will be
shown in reverse video.
5. There are two choices for changing feedrate values.
Type in a new value for the selected feedrate by using the keys on
the operator panel. Then press the
{REPLCE VALUE} softkey. The
value typed in will replace the old value for that feedrate.
Type in a value to add to the old value for the selected feedrate by
using the keys on the operator panel. Then press the
{ADD TO VALUE} softkey. The value typed in will be added to the
old value for that feedrate.
(softkey level 4)
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
6. To leave the feedrate parameter screen there are two choices.
To save the changes just made and leave the feedrate parameter
screen press the
{UPDATE & EXIT} softkey.
To leave the feedrate parameter screen without saving the changes
press the
{QUIT} softkey.
(softkey level 4)
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
END OF CHAPTER