Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual
Page 244
Displays and Graphics
Chapter 8
8-28
You may want to change the parameters to alter your graphics. If you want
to view a different graphics screen, you must change the default values for
the parameters. These are the default parameter values for QuickCheck:
PROCESS SPEED:
[FAST]
RAPID TRAVERSE:
[ON]
AUTO SIZE
[OFF]
GRID LINES
[OFF]
OVERTRAVEL/ZONE LINES
[OFF]
MAIN PROGRAM SEQUENCE STARTING #[0]
MAIN PROGRAM SEQUENCE STOPPING #[0]
These are the default parameter values for active graphics:
RAPID TRAVERSE
[ON]
AUTO ERASE
[ON]
AUTO SIZE
[OFF]
GRID LINES
[OFF]
OVERTRAVEL/ZONE LINES
[OFF]
Follow these steps to change your parameters. We assume you have
already completed the procedure to run graphics. See page 8-25 for details
on running a graphics program.
1.
To load parameters, press {GRAPH SETUP}.
(softkey level 4)
CLEAR
GRAPHS
MACHIN
INFO
ZOOM
WINDOW
ZOOM
BACK
GRAPH
SETUP
The control displays these graphics parameter screens:
CHECK RUN GRAPHICS PARAMETERS
USE
ACTIVE PROGRAM: G52
X
Z
PROCESS SPEED
FAST
RAPID TRAVERSE
ON
AUTO SIZE
OFF
GRID LINES
OFF
OVERTRAVEL/ZONE LINES
OFF
MAIN PROGRAM SEQUENCE STARTING #: 0
MAIN PROGRAM SEQUENCE STARTING #: 0
DEFALT
PARAM
SAVE
PARAM
DEFALT
PARAM
SAVE
PARAM
ACTIVE PROGRAM GRAPHICS PARAMETER
USE
ACTIVE PROGRAM: G21
X
Z
RAPID TRAVERSE
ON
AUTO ERASE
OFF
AUTO SIZE
OFF
GRID LINES
OFF
OVERTRAVEL/ZONE LINES
OFF