Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 270)

Communications
Chapter 9
9-14
3. Press the {COPY PRGRAM} softkey.
(softkey level 2)
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
REFORM
MEMORY
4. Enter the program name to output from memory. There are two ways
to do this:
Type in the program name using the alphanumeric keys on the key
board. The control displays program name on the input line (line
2 of the screen) next to the prompt “FILENAME”.
Use the up or down cursor keys to position the cursor at the
program it is desired to send. The control displays the selected
program in reverse video.
If outputting all programs, cursor to the first program in your
program directory.
5. Select the device you want to copy as follows:
If the peripheral device is connected to: Press this softkey:
Port A {MEM TO PORT A}
Port B {MEM TO PORT B}
(softkey level 3)
MEM TO
PORT A
FROM A
TO MEM
MEM TO
PORT B
FROM B
TO MEM
MEM TO
MEM
The Copy Parameters screen appears (see Figure 9.5).