Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 266)

Communications
Chapter 9
9-10
Figure 9.2
Program Directory Screen
SELECTED PROGRAM:
DIRECTORY PAGE 1 OF 1
NAME SIZE COMMENT
O12345 1.3 SUB TEST 1
TEST 3.9 NEW
MAIN 1.3
TTTE 1.3 THIS IS A TEST PROGRAM
XXX 1.3
5 FILES 120.7 METERS FREE
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
3. Press the {COPY PRGRAM} softkey.
REFORM
MEMORY
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
4. If the name is already entered in the program, skip step 4 and go to
step 5. Otherwise enter the program name to copy by either selecting
it using the up/down cursor keys or typing it in using the
alphanumeric keys on the keyboard. The program name is displayed
on the input line (line 2) of the screen next to the prompt
“FILENAME:”.
If an error is made while typing in the new program name,
corrections can be made on the input line as discussed in chapter 2.