Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 302)

Introduction to Programming
Chapter 10
10-28
G- Code Type Function Modal Group
G48 00 Reset Acc/Dec to Default AMPed Values Non--Modal
G48.1
00
Acceleration Ramp for Linear Acc/Dec Mode
Non--Modal
G48.2 Deceleration Ramp for Linear Acc/Dec Mode
G48.3 Acceleration Ramp for S--Curve Acc/Dec Mode
G48.4 Deceleration Ramp for S--Curve Acc/Dec Mode
G48.5 Programmable Jerk Value
G49 08 Tool Length Offset Cancel) Modal
G50.1 11 Programmable Mirror Image (Cancel) Modal
G51.1 Programmable Mirror Image
G52 00 Offsetting Coordinate Zero Point Non-Modal
G53 Motion in Machine Coordinate System
G54 12 Preset Work Coordinate System 1 Modal
G55 Preset Work Coordinate System 2
Modal
G56 Preset Work Coordinate System 3
G57 Preset Work Coordinate System 4
G58 Preset Work Coordinate System 5
G59 Preset Work Coordinate System 6
G59.1 Preset Work Coordinate System 7
G59.2 Preset Work Coordinate System 8
G59.3 Preset Work Coordinate System 9
G61 13 Exact Stop Mode Modal
G62 Automatic Corner Override
G63 Tapping Mode
G64 Cutting Mode
G65 00 Paramacro Call Non-Modal
G66 14 Paramacro Modal Call Modal
G66.1 Paramacro Modal Call
G67 Paramacro Modal Call (Cancel)
G68 16 Part Rotation Modal
G69 Part Rotation (Cancel)
G73 09 Deep Hole Peck Drilling Cycle (With dwell) Modal
G74 Left-Hand Tapping Cycle
G74.1 Left-Hand Solid Tapping Cycle
G76 Boring Cycle (Spindle Shift)
G80 Cancel or End Fixed Cycle
G81 09 Drilling Cycle (No Dwell, Rapid Out) Modal
G82 Drilling Cycle (Dwell, Rapid Out)
G83 Deep Hole Peck Drilling Cycle
G84 Right-Hand Tapping Cycle
G84.1 Right-Hand Solid Tapping Cycle
G85 Boring Cycle (No Dwell, Feed Out)