Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 46)

Basic Control Operation
Chapter 2
2-22
You see the main menu screen:
PROGRAM[ MM ] F 00000.000 MMPM
Z 00000.000 S
R X 00000.000 T 12345
C 359.99 FILENAME
SUB NAME 9999
MEMORY 30000 MDI STOP
(PAL messages)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
E-STOP
The softkeys available on the main menu screen are referred to as “level 1”
softkey functions. Some of the softkey functions are purchased as optional
and may not appear exactly as shown.
Follow this procedure to turn off power to the control:
CAUTION: To prevent damage to the machine, never turn off
power while a part program is being executed. Before turning
off power, make sure that the control is in CYCLE STOP.
1. Before you turn the power off, make sure that the control is in
CYCLE STOP.
2. Press the button.
3. Make sure that power is turned off to all peripheral devices (tape
reader, tape punch, etc.) that are connected to the control.
4. Press the power button.
2.4.2
Turning Power OFF