Softkey – Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual
Page 90

Offset Tables and Setup
Chapter 3
3-16
Figure 3.5
Work Coordinate System Setting
WORK COORDINATE TABLES
G54
[INCH]
G55
[ MM ]
G56
[ MM ]
X
-9999.9999
X
-9999.9999
X
-9999.9999
Y
-9999.9999
Y
-9999.9999
Y
-9999.9999
Z
-9999.9999
Z
-9999.9999
Z
-9999.9999
U
-9999.9999
U
-9999.9999
U
-9999.9999
G57
[INCH]
G58
[ MM ]
G59
[ MM ]
X
-9999.9999
X
-9999.9999
X
-9999.9999
Y
-9999.9999
Y
-9999.9999
Y
-9999.9999
Z
-9999.9999
Z
-9999.9999
Z
-9999.9999
U
-9999.9999
U
-9999.9999
U
-9999.9999
REPLCE
VALUE
ADD TO
VALUE
INCH/
METRIC
RADI/
DIAM
MORE
OFFSET
3.
Move the cursor to the offset data to be modified. Use the up, down,
left, or right cursor keys to move the block cursor to the offset data on
the current page. Press the
{MORE OFFSET}
softkey to change pages.
The selected item will be shown in reversed video.
Important: To modify the active work coordinate system, the control
must be in ESTOP, or CYCLE-STOP and END OF BLOCK. If it is not,
the control, along with generating the error message “ACTIVE OFFSET
CAN NOT CHANGE”, will not update the work coordinate table.
4.
Units selection
{INCH/METRIC}
To select units of “mm” or “inch”, press the
{INCH/METRIC}
softkey.
(softkey level 3)
REPLCE
VALUE
ADD TO
VALUE
INCH/
METRIC
RADI/
DIAM
MORE
OFFSET
When the units are altered, all data previously entered for a particular
coordinate system or offset is converted to the newly selected units
(Inch or Metric). The current units are displayed to the right of the
work coordinate system or the offset that is being changed.