Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 45)

Basic Control Operation
Chapter 2
2-21
Figure 2.4
Jog Retract Software MTB Panel Screen
JOG
AXES+
JOG
AXES-
E-STOP
PROGRAM[ MM ] F 00000.000 MMPM
Z 00000.000 S 0
R X 00000.000 T 12
C 359.99 FILENAME
SUB NAME
MEMORY MAN STOP
The basic procedure for turning power on and off is described in this
section. Refer to the documentation prepared by your system installer for
more specific procedures.
Follow this procedure to turn on power to the control:
1. Visually check to make sure that the control and the machine are in
normal operating conditions.
2. Press the power button.
Important: Do not touch any other buttons after you press the power
button until characters appear and remain on the screen.
3. If characters are not displayed on the screen within 15 seconds, press
the power
button immediately.
Important: If the screen does not display characters after you press the
power
button within a reasonable warm up period (about 15 seconds),
immediately press the power button and contact service personnel.
To activate the main menu, press the [TRANSMIT] key.
2.4
Power Procedures
2.4.1
Turning Power On