Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 53)

Basic Control Operation
Chapter 2
2-29
The following section describes the functions on the 9/Series control that
can be protected from an operator by the use of a password. If a user has
access to a function, the parameter associated with that function is shown
in reverse video on the access control screen.
Access to these functions can be controlled by passwords. Table 2.E
describes the function that is enabled (the operator can perform them) if
the parameter name is shown in reverse video. If the function is not shown
in reverse video, the function is protected and cannot be accessed.
Some parameters enable more than one function. If a parameter that
enables multiple functions is not selected as accessible, some of the
functions that would be enabled by the parameter can be enabled
individually by using other parameters.
Table 2.E
Password Protectable Functions
Parameter Name: Function becomes accessible when parameter name is in reverse video:
1) ACTIVE PROGRAM To access these features, both ACTIVE PROGRAM and PROGRAM MANAGE (number 2 below) must be
assigned to the user.
• {SELECT PRGRAM} — Select a program for automatic operation.
• {SEARCH} — Search a part program for a character string or sequence number to begin program
execution at.
• {MID ST PRGRAM} — Start program execution from some location other than the beginning and
still set all of the parameters previously defined in the program active.
• {T PATH GRAPH} — Enable the active graphics feature.
• {CANCEL PRGRAM} — Disable the currently active program from execution.
• {SEQ STOP} — Choose a sequence number for program automatic program execution to stop at.
2) PROGRAM MANAGE • {ACTIVE PRGRAM} — All of the functions in 1 above provided ACTIVE PROGRAM (number 1
above) is also selected.
• {EDIT PRGRAM} — Edit an existing program or create a new program.
• {DISPLY PRGRAM} — Display a program using the display function.
• {COPY PRGRAM} — Copy a program to or from memory.
• {VERIFY PRGRAM} — Verify that two programs are identical using the verify function.
• {COMENT} — Add comments to a program name in the directory.
• {RENAME PRGRAM} — Change a program name.
• {DELETE PRGRAM} — Delete a single program stored in memory.
• {REFORM MEMORY} — Delete all programs currently stored in memory.
3) EDIT PROGRAM {EDIT PRGRAM} — Edit an existing program or create a new program.
4) COPY PROGRAM {COPY PRGRAM} — Copy a program to or from memory or storage device.
5) RENAME PROGRAM {RENAME PRGRAM} — Not rename a program name.
6) DELETE PROGRAM {DELETE PRGRAM} — Delete a single program stored in memory
7) DELETE ALL PROG {REFORM MEMORY} — Delete all programs currently stored in memory.
2.7.2
Password Protectable
Functions