Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 44)

Basic Control Operation
Chapter 2
2-20
2. Select one of these softkey options:
block retrace
jog retract
cycle start
cycle stop
To Perform a: Press:
Cycle Start the softkey that corresponds to the desired feature. Details on these
features are described in chapter 7.
Cycle Stop the softkey that corresponds to the desired feature. Details on these
features are described in chapter 7.
Block Retrace the {BLOCK RETRCE} softkey. The control automatically
retraces the previously executed block each time you press. The tool
returns to the start point of Block Retrace when you press the
{CYCLE START} softkey. Details on Block Retrace can be found
in chapter 7.
Jog Retract the {JOG RETRCT} softkey. This calls up the jog retract screen.
Select: the axis, the type of jog, the speed multiply value (see
chapter 4), or the HPG number (if HPG has been selected as the
type of jog). Use the up and down cursor keys to select the function,
and the left and right cursor keys to alter the value assigned to that
function.
3. If you selected JOG RETRACT, press the {JOG AXES +} or
{JOG AXES -} softkeys to select the direction to jog the axis. Press
the exit {
•
} softkey when you complete the jog retract. The cutting
tool automatically retraces the jog moves you made when you pressed
the
{CYCLE START} . See chapter 7.
(softkey level 4)
SET
ZERO
JOG
AXES +
JOG
AXES-