Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 931)

Allen-Bradley 7300 Series CNC
Tape Compatibility
Appendix D
D-9
The main program, which has the pattern repeat call block “(CP, name, r)”,
can be executed from tape or from the control’s memory. However, if you
want to make minor editing to your main program, you must copy the
program into the control’s memory. Refer to Section 9.2, “Inputting Part
Programs,” for details on how to copy a program from tape.
Important: To execute a program from tape, the tape must be positioned
at the start of the main program.
For more information on how subprograms are executed in the control,
refer to chapter 10, “Subprogram Call (M98).”
You may enhance your 7300 part program flexibility with selected 9/Series
features. Table D.C lists the control’s G-codes that can be executed in
7300 mode. However, we recommend that you use the 9/Series
programming method for optimal performance. Refer to earlier sections of
this manual for details on these G-codes.
Table D.C
Mill G-codes Available in 7300 Mode
G-code: Description:
G09 Exact stop
G10L2 Set up work coordinate offset table
G10L3 Set up tool management table
G10L10 Set up tool offset geometry table
G10L11 Set up tool offset wear table
G10L12 Set up tool diameter wear table
G10L13 Set up tool diameter geometry table
G11 Set up tool management table cancel
G14 Disable scaling
G27 Machine home return check
G28 Automatic return to home
G29 Automatic return from home
G30 Return to secondary home
G31 External skip function 1
G36 Short block Acc/Dec disabled
G37 Tool gauging skip function 1
G38 Hole probing
G39 Cutter compensation (linear transition)
G43 Tool length plus
G44 Tool length minus
9/Series G-codes Applicable
to the 7300 Series CNC