Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 303)

Introduction to Programming
Chapter 10
10-29
G- Code Type Function Modal Group
G86 Boring Cycle (Spindle Stop, Rapid Out)
G87 Back Boring Cycle
G88 Boring Cycle (Spindle Stop, Manual Out)
G88.1 00 Pocket Milling Roughing Cycle Non--Modal
G88.2 Pocket Milling Finishing Cycle
G88.3 Pocket Milling Roughing Cycle
G88.4 Pocket Milling Finishing Cycle
G88.5 Hemispherical Milling (Roughing Cycle)
G88.6 Hemispherical Milling (Finishing Cycle)
G89 09 Boring Cycle (With Dwell, Feed Out) Modal
G89.1 00 Irregular Pocket Milling (Roughing Cycle) 1 Non--Modal
G89.2 Irregular Pocket Milling (Finishing Cycle) 1
G90 03 Absolute Mode Modal
G91 Incremental Mode
G92 00 Coordinate System Offset (Using Tool Positions) Non-Modal
G92.1 Coordinate System Offset (Cancel)
G92.2 Selected Coordinate System Offsets (Cancel)
G93 05 Inverse Time Feed Mode Modal
G94 Feed-per-minute mode
G95 Feed-per-revolution Mode
G98 10 Initial Level Return in Milling Cycles Modal
G99 R-Point Level Return in Milling Cycles
1 Important: The Irregular Pocket Milling Cycles feature (G89.1 and G89.2) is only available prior to system
software release 12.xx. Any attempt to program a G89.1 or G89.2 in release 12.xx or later will result in the error
message, “Illegal G--code”.
A set of default G--codes become effective at power up, when the control is
reset, or an emergency stop condition is reset. These default G--codes are
selected by the system installer in AMP. These default G--codes can be
seen on the status display screen after power up or control reset.