Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual

Page 94

Offset Tables and Setup

Chapter 3

3-20

Once the data to save has been selected, determine the destination for
the G10 program from these three options:

Press the

{TO PORT A}

softkey to send the G10 program to a

peripheral attached to port A.

Press the

{TO PORT B}

softkey to send the G10 program to a

peripheral attached to port B.

Press the

{TO FILE}

softkey to send the G10 program to control

memory.

When the

{TO FILE}

softkey is pressed, the control will ask for a

program name to store the program as. Enter the program name
using the alphanumeric keys on the operator panel and press the

[TRANSMIT]

key (See the section on program names in chapter 10).

The G10 program will be saved under the file name just entered.